Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

SolidWorks Model E-Car Tutorials

Welcome to Our SolidWorks 2009 Model E-Car Tutorials. Our tutorials are written for SolidWorks 2009. The following tutorials with the PDF icon are available for download. Download the free reader from Adobe.
Any questions contact us at

   

Table of Contents

Part 1. Chassis.
Part 2. Axles.
Part 3. Wheels.
Part 4. Motor.
Part 5. Motor Mount. Use as a pattern for sheet metal motor mounts.
Part 6. L-Bracket and Switch.
Part 7. Battery 9 Volt.
Part 8. Battery 9 Volt Clip.
Assembly 9. Assembly.
Drawing 10. Drawing. 11” by 17” paper. Click here to view pdf drawing.
Part 11. Slot Wood Block. Simple wood block to hold slot wood.
Part 12. Slot Wood. Slot wood adjust into down position to run on track. Swing slot wood up to run off track with 9 volt battery.
Part 13. Pulley with Mates.
Part 14. Rubber Band Belt with Mates.
Part 15. Braided Wire with Mates. Braided wire is use as “brushes” to brush against track.
Toolbox 16. Screws from Toolbox.