Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

SolidWorks 2012 Model E-Car Tutorials

Welcome to Our SolidWorks 2012 Model E-Car Tutorials. Our tutorials are written for SolidWorks 2012. The following tutorials with the PDF icon and MP4 icon are available for viewing. Download the free reader from Adobe.

Tutorials include Mate References on the Wheel and Axles. These parts "snap" to axle holes in Chassis when inserting into Assembly file. Sheet Metal parts also include Mate References and snap to Chassis when inserting into the Assembly file.

Any questions contact us at

     

Table of Contents

Part 1. Chassis. Now includes cylindrical and center plane Mate References for Axles.
Part 2. Axles.
Part 3. Wheels.
Part 4. Motor.
Part 5. Motor Mount. Use as a pattern for sheet metal motor mounts.
Part 6. L-Bracket and Switch.
Part 7. Battery 9 Volt.
Part 8. Battery 9 Volt Clip.
Assembly 9. Assembly.
Drawing 10. Drawing. 11” by 17” paper.
Part 11. Slot Wood Block. Wood block to hold slot wood.
Part 12. Slot Wood. Slot wood adjust into down position to run on track. Swing slot wood up to run off track with 9 volt battery.
Part 13. Pulley with Mates.
Part 14. Rubber Band Belt with Mates.
Part 15. Braided Wire with Mates. Braided wire is use as “brushes” to brush against track.
Toolbox 16. Screws from Toolbox.
         
Here are 2013 and 2009 tutorials.